Best practices for setting up ClearID for a new Synergis system

2026-04-29Last updated

Consider the following best practices when building a new Synergis™ system to align with Genetec ClearID™ for an eventual ClearID implementation.

This information is intended for end users, integrators, or deployment contacts who are responsible for planning, designing, and configuring a ClearID system.

Because every system has different requirements, these best practices alone cannot be used to deploy your system. The deployment steps vary depending on your organization's architecture and current setup.
  • Use this information as a starting point only for basic planning purposes.
  • If you require help with your deployment, contact your deployment contact.
Ensure that you always test your new deployment implementation in a demo environment before applying to your production environment.

Pre-ClearID deployment tasks

  1. Plan your Sites and Areas to suit your access requirements.

    Use meaningful names that relate to the sites or areas that end users will request.

    1. Plan out the Sites and Areas that require access control.
      • Example sites: Main building, Satellite office 1, Satellite office 2 and so on.
      • Example areas: 1st floor, 2nd floor, server room, auditorium, and so on.
      A site is typically one physical building or a cluster of buildings in close proximity. The site configuration applies to the entire site so it should be controlled by the same sets of policies (access configurations and visitor management configurations).
    2. Plan out the Roles that you require for your access and identity grouping.
      • Example roles: Sales, Marketing, Executives, Faculty, Students, Production crew, Contractors, All permanent employees, All part-time employees.
    3. (Optional) Consider attribute-based provisioning to automate role memberships.

    Make a note of these sites, areas, and roles for use during the deployment tasks (steps 3 and 4) detailed later in this procedure.

  2. (Optional) Test your setup and configuration in a ClearID demo environment.
    1. Connect your ClearID demo account to a Synergis demo system.
    2. Contact your Genetec Inc. representative to request a ClearID DEMO account and a Synergis demo system.The configuration performed in a demo environment cannot be migrated to a production system.

Deployment tasks

  1. Connect your new production Synergis system with your ClearID production account.
    1. Install the ClearID plugin.
    2. Connect Security Center to ClearID.
  2. Synchronize identities with your data source.
    Depending on your specific requirements, do one of the following:
  3. In the ClearID web portal, create the sites and areas that you planned earlier.
    1. Create your sites.
    2. Create your areas.
  4. In the ClearID web portal, create the roles and attribute provisioning policies that you planned earlier.
    1. Create your roles.
    2. (Optional) Create attribute-based provisioning policies to automate role memberships.